Engineering Mechanics

International Conference

Proceedings Vol. 12 (2006)


ENGINEERING MECHANICS 2006

NATIONAL CONFERENCE WITH INTERNATIONAL PARTICIPATION
May 15 – 18, 2006, Svratka, Czech Republic
;
Editors: Jiří Náprstek and Cyril Fischer

Copyright © 2006 Institute of Theoretical and Applied Mechanics, Academy of Sciences of the Czech Republic, Prague

ISBN 80-86246-27-2 (printed, Extended Abstracts)
ISSN 1805-8248 (printed)
ISSN 1805-8256 (electronic)

list of papers scientific commitee

The residual stress determination by the hole drilling method by means of the influence function
K. Švaříček, M. Vlk
pages 368 - +13p., full text

The hole drilling method is widely used for residual stresses measurement. The evaluation of the inhomogeneous residual stresses through the depth can be performed by the integral method or power series method. The calibration coefficients are necessary to determinate by the finite element method for each method separately. The determination of the calibration coefficients takes usually much time. The generally view of the residual stress determination gives the influence function. The problem of the influence function solved Beghini (2000). The calibration coefficients for the integral method and for the power series method and for an arbitrary “new” method can be determined by the influence function. The base of the integral method consists in the approximation of the residual stress by a piecewise constant function. The base of the power series method consists in the approximation of the residual stress by a polynomial function. The new method would be consisted in an approximation of an arbitrary function. In this paper the influence function is determined for the strain gauge rosette RY 61 S. Then the influence function is used for the residual stress determination. Further the calibration coefficient of the integral method was compared with the calibration coefficients determined by the influence function which was provided with kindness by M. Beghini from University of Pisa, Italy.


back to list of papers

Text and facts may be copied and used freely, but credit should be given to these Proceedings.

All papers were reviewed by members of the scientific committee.


Publication Ethics - Ethical guidelines for publication
Webmaster contact: admin@it.cas.cz

imce   Powered by Imce 3.20  © 2023, Pavel Formánek, Institute of Thermomechanics AS CR, v.v.i. [generated: 0.0275s]