Proceedings Vol. 19 (2013)
ENGINEERING MECHANICS 2013
May 13 – 16, 2013, Svratka, Czech Republic
Copyright © 2013 Institute of Thermomechanics, Academy of Sciences of the Czech Republic, v.v.i., Prague
ISSN 1805-8248 (printed)
ISSN 1805-8256 (electronic)
list of papers scientific commitee
pages 62 - 69, full text
The article deals with Magnetostatic analysis of a magnetorheological (MR) clutch. The analysis is needed for acquiring information about magnetic saturation of iron parts in operation mode. This paper describes a comparison of FEM model and experimentally measured data in the clutch´s working gap filled with the air. The most important parameters such as use of linear and nonlinear material (iron parts, MR fluid), element type and size, effect of measuring groove for Hall sensor on magnetic field distribution, which significantly improved the FEM model of the simulation were determined, and they are also mentioned bellow. Simulation based on the verified FEM model of magnetic circuit with MR fluid was completed. Results showed places, where it is possible to reduce the material without any changes to the magnetic flux density in the working gap. With this knowledge, we reduced the weight by 13,2%.
back to list of papers
Text and facts may be copied and used freely, but credit should be given to these Proceedings.
All papers were reviewed by members of the scientific committee.
Powered by
Imce 3.20 © 2023, Pavel Formánek, Institute of Thermomechanics AS CR, v.v.i. [generated: 0.0314s]